REAR SUNSHADE SWITCH (for Rear Side) REASSEMBLY

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSTALL COOLER CONTROL SWITCH KNOB


    1. Install the rubber switch to the cooler control switch knob (rear sunshade switch).

    2. A01FILF

      Install the circuit board sub-assembly with the 3 screws.

      Note


      • When replacing the cooler control switch knob, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the circuit board sub-assembly from being damaged.

      • Do not damage the circuit board sub-assembly.

    3. A01FGEM

      Install the cooler control switch knob to the cooler control case.

      Note


      • When replacing the cooler control switch knob, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the circuit board sub-assembly from being damaged.

      • Do not damage the circuit board sub-assembly.

  2. INSTALL COOLER CONTROL SWITCH PANEL


    1. Attach the 12 claws to install the cooler control switch panel.

    2. Install the 3 screws.