REAR SUNSHADE SWITCH (for Front Side) INSPECTION

Tech Tips

Use the same procedure for RHD and LHD vehicles.


  1. INSPECT REAR SUNSHADE SWITCH ASSEMBLY

    A01FH5BE01
    Text in Illustration
    *a

    Component without harness connected

    (Rear Sunshade Switch Assembly)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      3 (ECU) - 4 (E)

      Rear sunshade switch on

      (Pushed)

      		 Below 1 Ω
      3 (ECU) - 4 (E)

      Rear sunshade switch off

      (Not pushed)

      		 10 kΩ or higher

      If the result is not as specified, replace the rear sunshade switch assembly.

    2. A01FH5BE02
      Text in Illustration
      *a

      Component without harness connected

      (Rear Sunshade Switch Assembly)

      Apply battery voltage to the switch connector and check that the rear sunshade switch illuminates.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 2 (ILL+)

      Battery negative (-) → Terminal 5 (ILL-)

      		 Illuminates

      If the result is not as specified, replace the rear sunshade switch assembly.