REAR SEAT OUTER BELT ASSEMBLY INSPECTION


  1. INSPECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY


    1. A01FD8KE01
      Text in Illustration
      *1 Tension Reducer Connector
      *2 Pretensioner Connector
      *a

      Component without harness connected

      (Rear Seat 3 Point Type Outer Belt Assembly)

      Check tension reducer operation.

      Note

      Do not apply battery voltage to the pretensioner connector.


      1. Connect a positive (+) lead of the battery to terminal 1 (IG) of the tension reducer connector and a negative (-) lead to terminal 2 (L).

      2. Check that an operating sound is heard when the magnetized solenoid is attracting the plunger.

      3. Pull out the seat belt and allow it to retract. Listen to the operating sound.

      4. Pull out the seat belt again, disconnect the negative (-) lead of the battery and allow the seat belt to retract. Listen to the operating sound again and check that the operating sound volume has increased.

        If the result is not as specified, replace the rear seat 3 point type outer belt assembly.

    2. A01FIVKE06
      Text in Illustration
      *a 45°

      Check the degree of tilt when the ELR begins to lock.


      1. Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt while gently pulling the belt.

        Note

        Do not disassemble the retractor.