POWER WINDOW REGULATOR MOTOR (for Front Door) INSPECTION


  1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

    A01FINFE01
    Text in Illustration
    *1 Motor Gear
    *a

    Component without harness connected

    (Power Window Regulator Motor Assembly LH)
    A01FGIV Clockwise
    A01FJ4N Counterclockwise

    Note

    Do not apply positive (+) battery voltage to any terminals, except terminal 2 (B), to avoid damaging the pulse sensor inside the motor.


    1. Apply positive (+) battery voltage to the connector terminal 2 (B).

    2. Apply negative (-) battery voltage to the connector terminals 1 (E) and 7 (DWN1) / 10 (UP1).

    3. Check that the motor gear rotates smoothly as follows.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 2 (B)

      Battery negative (-): 1 (E) (3 seconds or more) → 1 (E) and 10 (UP1) (within 1 second) → 1 (E) (within 1 second) → 1 (E) and 10 (UP1)

      		 Motor gear rotates clockwise (UP)

      Battery positive (+) → 2 (B)

      Battery negative (-): 1 (E) (3 seconds or more) → 1 (E) and 7 (DWN1) (within 1 second) → 1 (E) (within 1 second) → 1 (E) and 7 (DWN1)

      		 Motor gear rotates counterclockwise (DOWN)

      If the result is not as specified, replace the power window regulator motor assembly LH.

      CAUTION:

      Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly onto the door.

  2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

    A01FETTE01
    Text in Illustration
    *1 Motor Gear
    *a

    Component without harness connected

    (Power Window Regulator Motor Assembly LH)
    A01FGIV Clockwise
    A01FJ4N Counterclockwise

    Note

    Do not apply positive (+) battery voltage to any terminals, except terminal 2 (B), to avoid damaging the pulse sensor inside the motor.


    1. Apply positive (+) battery voltage to the connector terminal 2 (B).

    2. Apply negative (-) battery voltage to the connector terminals 1 (E) and 7 (DWN1) / 10 (UP1).

    3. Check that the motor gear rotates smoothly as follows.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 2 (B)

      Battery negative (-): 1 (E) (3 seconds or more) → 1 (E) and 10 (UP1) (within 1 second) → 1 (E) (within 1 second) → 1 (E) and 10 (UP1)

      		 Motor gear rotates clockwise (UP)

      Battery positive (+) → 2 (B)

      Battery negative (-): 1 (E) (3 seconds or more) → 1 (E) and 7 (DWN1) (within 1 second) → 1 (E) (within 1 second) → 1 (E) and 7 (DWN1)

      		 Motor gear rotates counterclockwise (DOWN)

      If the result is not as specified, replace the power window regulator motor assembly RH.

      CAUTION:

      Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly onto the door.