POWER WINDOW CONTROL SYSTEM Rear Power Window RH Auto Up / Down Function does not Operate with Rear Power Window Switch RH

DESCRIPTION

If the auto up/down function does not operate, the cause may be one or more of the following:


WIRING DIAGRAM

A01FDA0E03

INSPECTION PROCEDURE

Note


  • If the power window regulator motor assembly has been replaced with a new one, initialize the power window control system Click here.

  • If the power window regulator motor assembly and door window regulator sub-assembly have been removed and installed, or if the power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system Click here.

PROCEDURE


  1. READ VALUE USING GTS (RR DOOR P/W AUTO SW)


    1. Use the Data List to check if the power window regulator switch is functioning properly Click here.

      RR-Door Motor
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      RR Door P/W Auto SW Rear power window RH auto up/down signal / ON or OFF

      ON: Rear power window RH auto up/down switch operated

      OFF: Rear power window RH switch not operated

      -
      OK
      On GTS screen, item changes between ON and OFF according to above chart.

    NG
    OK
  2. PERFORM INITIALIZATION


    1. Initialize the power window regulator motor assembly Click here.

    2. Check that the rear RH side door power window moves when the auto up and down functions of the rear power window regulator switch assembly RH are operated Click here.

      OK
      Rear RH side auto up and down functions are normal.

    NG
    OK
  3. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH


    1. A01FFKQE05

      Remove the rear power window regulator switch assembly RH Click here.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      4 (AUTO) - 5 (GND) Auto up/down operation Below 1 Ω
      4 (AUTO) - 5 (GND) Not operated 10 kΩ or higher

    NG
    OK
  4. CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH - REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH AND BODY GROUND)


    1. Disconnect the R6 rear power window regulator switch assembly RH connector.

    2. Disconnect the R1 rear power window regulator motor assembly RH connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      R6-4 (AUTO) - R1-4 (AUTO) Always Below 1 Ω
      R6-5 (GND) - Body ground Always Below 1 Ω
      R6-4 (AUTO) - Body ground Always 10 kΩ or higher

    NG
    OK