OIL PUMP REASSEMBLY


  1. INSTALL FRONT OIL PUMP OIL SEAL


    1. A01FGM7E01

      Using SST and a hammer, install a new front oil pump oil seal.

      SST
      09350-30020   ( 09351-32140 )
      Oil seal drive in depth
      -0.2 to 0.2 mm (-0.00787 to 0.00787 in.)

      Tech Tips

      The front oil pump oil seal end should be flush with the outer edge of the front oil pump body sub-assembly.

    2. Coat the front oil pump oil seal lip with MP grease.

  2. SECURE FRONT OIL PUMP BODY SUB-ASSEMBLY


    1. Place the front oil pump body sub-assembly on the torque converter assembly.

  3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    1. A01FDZ3

      Coat the front oil pump driven gear with ATF.

    2. Install the front oil pump driven gear to the front oil pump body sub-assembly.

  4. INSTALL FRONT OIL PUMP DRIVE GEAR


    1. A01FHNJ

      Coat the front oil pump drive gear with ATF.

    2. Install the front oil pump drive gear to the front oil pump body sub-assembly.

  5. INSTALL FRONT OIL PUMP BODY O-RING


    1. A01FHWK

      Install a new front oil pump O-ring to the front oil pump body sub-assembly.

  6. INSTALL STATOR SHAFT ASSEMBLY


    1. A01FGXP

      Align the stator shaft assembly with each bolt hole.

    2. Using a T30 "TORX" wrench, install the 14 hexagon bolts.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }

  7. INSTALL CLUTCH DRUM OIL SEAL RING


    1. A01FE3VE09

      Coat 3 new clutch drum oil seal rings with ATF.

    2. Squeeze the ends of the 3 clutch drum oil seal rings so that the gap distance becomes 8 mm or less, and then install them to the stator shaft assembly groove.

      Note

      Do not expand the ring ends excessively.

      Tech Tips

      After installing the clutch drum oil seal rings, check that they rotate smoothly.

  8. INSPECT OIL PUMP DRIVE GEAR ROTATION


    1. A01FFO6

      Make sure that the oil pump drive gear rotates smoothly.

    2. Remove the oil pump assembly from the torque converter.

  9. INSTALL STATOR SHAFT O-RING


    1. A01FJ2Y

      Install a new stator shaft O-ring to the oil pump assembly.