COMBINATION SWITCH INSPECTION


  1. INSPECT COMBINATION SWITCH ASSEMBLY


    1. A01FI2OE02
      Text in Illustration
      *a

      Component without harness connected

      (Combination Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Switch Condition Specified Condition
      7 - 4 Mode switch being turned and held at SPORT position Below 10 Ω
      ↑ Mode switch not turned 10 kΩ or higher
      3 - 4 Mode switch being pushed and held Below 10 Ω
      ↑ Mode switch not pushed 10 kΩ or higher
      2 - 4 Press continuously combination switch (SNOW) Below 10 Ω
      ↑ Release combination switch (SNOW) 10 kΩ or higher
      4 - 8 Mode switch being turned and held at ECO position Below 10 Ω

      If the result is not as specified, replace the combination switch assembly.