PARK / NEUTRAL POSITION SWITCH REMOVAL


  1. REMOVE FRONT SUSPENSION MEMBER BRACE


    1. A01FGRB

      Remove the 4 bolts, and then turn the clip and remove the front suspension member brace.

      Tech Tips

      Do not remove the clip from the front suspension member brace.

  2. REMOVE NO.2 ENGINE UNDER COVER


    1. A01FGRO

      Remove the 4 screws, 2 grommets and No. 2 engine under cover.

  3. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY


    1. A01FELG

      Remove the clip and pin, and disconnect the floor shift gear shifting rod sub-assembly from the transmission control shaft lever RH.

  4. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. A01FGTKE06
      Text in Illustration
      *a Front

      Disconnect the park/neutral position switch connector.

    2. A01FGOZ

      Remove the nut, spring washer and transmission control shaft lever RH.

    3. A01FFZME06
      Text in Illustration
      *1 Lock Washer
      *2 Lock Nut

      Using a screwdriver, pry out the lock washer.

    4. A01FH2X

      Remove the lock nut and lock washer.

    5. A01FFKB

      Remove the bolt and park/neutral position switch.

      Tech Tips

      Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.