MILLIMETER WAVE RADAR SENSOR REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A01FFHV

      Remove the 4 clips and engine room side cover.

  2. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01FGB0

      Remove the 7 clips and cool air intake duct seal.

  3. REMOVE FRONT BUMPER COVER


    1. A01FEH9

      Remove the 8 screws.

    2. A01FFBJE01

      Using a screwdriver, turn the 2 pin hold clips 90° and remove the pin hold clips and screw.

      Tech Tips

      Use the same procedure for the pin hold clips and screw on the other side.

    3. A01FGNI

      Remove the 5 clips.

    4. A01FGLPE01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the front bumper cover.

    5. Detach the 10 claws and remove the front bumper cover.

    6. w/ Headlight Cleaner System:


      1. Disconnect the 2 headlight washer hoses and then drain the washer fluid.

        Tech Tips

        Use a container to collect the washer fluid.

    7. w/ LEXUS Parking Assist-sensor System:


      1. Disconnect the No. 4 engine room wire.

        A01FDJD

  4. REMOVE FRONT BUMPER ENERGY ABSORBER


    1. Remove the front bumper energy absorber.

      A01FF5GE01
      Text in Illustration
      *A for Type A *B for Type B

  5. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY


    1. A01FFLW

      Disconnect the connector.

    2. Detach the clamp.

    3. A01FDPT

      Remove the 3 bolts and millimeter wave radar sensor assembly.