OIL LEVEL SENSOR INSTALLATION


  1. INSTALL ENGINE OIL LEVEL SENSOR


    1. Install a new gasket to the engine oil level sensor.

    2. Install the engine oil level sensor with the 4 bolts.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

      Tech Tips

      Be sure to clean the contact surface.

    3. Connect the engine oil level sensor connector.

  2. ADD ENGINE OIL


    1. Add clean engine oil.

      Note

      Do not allow engine oil to adhere to the moving parts of the belt tensioner, as this may cause malfunctions.

      A01FF7U

      If engine oil is on the location indicated by the arrow, replace the belt tensioner.

      Standard Oil Grade
      Oil Grade Oil Viscosity (SAE)

      • API grade SL "energy-conserving", SM "energy-conserving", SN "resource-conserving" or ILSAC multigrade engine oil

      • 5W-30

      • 10W-30
      API grade SL, SM or SN multigrade engine oil

      • 15W-40

      • 20W-50
      Standard Oil Grade (for Korea)
      Oil Grade Oil Viscosity (SAE)

      • API grade SL "energy-conserving", SM "energy-conserving", SN "resource-conserving" or ILSAC multigrade engine oil

      • 0W-20

      • 5W-20

      • 5W-30

      • 10W-30
      API grade SL, SM or SN multigrade engine oil

      • 15W-40

      • 20W-50
      Standard Capacity
      Item Specified Condition (for 2WD) Specified Condition (for AWD)
      Drain and refill without oil filter change 5.9 liters (6.2 US. qts., 5.2 Imp. qts.) 6.0 liters (6.3 US. qts., 5.3 Imp. qts.)
      Drain and refill with oil filter change 6.3 liters (6.7 US. qts., 5.5 Imp. qts.) 6.4 liters (6.7 US. qts., 5.6 Imp. qts.)
      Dry fill 7.2 liters (7.6 US. qts., 6.3 Imp. qts.) 7.7 liters (8.1 US. qts., 6.8 Imp. qts.)

    2. Install the oil filler cap.

  3. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that no oil leaks from the connection point of the oil filter cap.

  4. INSPECT ENGINE OIL LEVEL


    1. Warm up and stop the engine, and then wait for 5 minutes. The oil level should be between the dipstick's low level mark and full level mark.

      If low, check for leakage and add oil up to the full level mark.

      Note

      Do not add engine oil to above the full level mark.

  5. INSTALL NO. 2 ENGINE UNDER COVER (for 2WD)


    1. Install the No. 2 engine under cover with the 4 screws.

  6. INSTALL FRONT SUSPENSION MEMBER BRACE (for 2WD)


    1. Install the front suspension member brace with the clip and 4 bolts.

      Torque:
      52 N*m  { 530 kgf*cm, 38 ft.*lbf }