OIL LEVEL SENSOR REMOVAL


  1. DRAIN ENGINE OIL


    1. Remove the oil filler cap.

    2. Remove the drain plug and gasket.

    3. Install a new gasket and the drain plug.

      Torque:
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

  2. REMOVE FRONT SUSPENSION MEMBER BRACE (for 2WD)


    1. A01FGB1

      Remove the 4 bolts, and then turn the clip and remove the front suspension member brace.

      Tech Tips

      Do not remove the clip from the front suspension member brace.

  3. REMOVE NO. 2 ENGINE UNDER COVER (for 2WD)


    1. A01FF5C

      Remove the 4 screws and No. 2 engine under cover.

  4. REMOVE ENGINE OIL LEVEL SENSOR


    1. A01FG6QE01
      Text in Illustration
      *A for 2WD
      *B for AWD

      Disconnect the engine oil level sensor connector.

    2. Remove the 4 bolts and engine oil level sensor.

    3. A01FDY8E01
      Text in Illustration
      *1 Cutting Position
      *2 Supply Part

      Cut off the gasket as shown in the illustration.

    4. Remove the gasket from the engine oil level sensor.

      Tech Tips

      After cutting away the parts of the gasket shown in the illustration, remove only the outer part of the gasket.