EXHAUST MANIFOLD REMOVAL


  1. REMOVE AIR FUEL RATIO SENSOR

    Click here

  2. REMOVE FRONT SUSPENSION MEMBER BRACE


    1. A01FGRB

      Remove the 4 bolts, and then turn the clip and remove the front suspension member brace.

      Tech Tips

      Do not remove the clip from the front suspension member brace.

  3. REMOVE NO. 2 ENGINE UNDER COVER


    1. A01FGRO

      Remove the 4 screws, 2 grommets and No. 2 engine under cover.

  4. REMOVE NO. 1 REAR FLOOR BOARD SUB-ASSEMBLY


    1. A01FIXV

      Remove the 4 grommets, 7 clips and No. 1 rear floor board sub-assembly.

  5. REMOVE NO. 2 REAR FLOOR BOARD SUB-ASSEMBLY


    1. A01FG9R

      Remove the 4 grommets, 7 clips and No. 2 rear floor board sub-assembly.

  6. REMOVE FRONT CENTER FLOOR BRACE


    1. A01FE0M

      Remove the 6 bolts, 2 nuts, 2 clips and front center floor brace.

  7. DISCONNECT HEATED OXYGEN SENSOR


    1. for Bank 1 Sensor 2:


      1. A01FECSE01
        Text in Illustration
        *1 Grommet

        Disconnect the grommet of the heated oxygen sensor.

      2. A01FENTE01

        Using SST, disconnect the heated oxygen sensor.

        SST
        09224-00010

    2. for Bank 2 Sensor 2:


      1. A01FD99E01
        Text in Illustration
        *1 Grommet

        Disconnect the grommet of the heated oxygen sensor.

      2. A01FGR0E01

        Using SST, disconnect the heated oxygen sensor.

        SST
        09224-00010

  8. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. A01FDFD

      Remove the 4 nuts, 8 bolts, 4 compression springs and front exhaust pipe assembly.

    2. Remove the 4 gaskets.

    3. w/ Protector:

      Tech Tips

      Only perform this procedure when replacement of the front No. 1 exhaust pipe protector is necessary.

      A01FE6G

      1. Remove the bolt and clamp.

      2. Remove the 2 bolts, 2 nuts, exhaust pipe protector stay and front No. 1 exhaust pipe protector.

  9. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY


    1. A01FFX1

      Remove the 2 bolts and No. 1 exhaust pipe support bracket.

  10. REMOVE NO. 2 ENGINE OIL LEVEL DIPSTICK GUIDE


    1. A01FF1R

      Remove the oil level dipstick.

    2. Remove the bolt and No. 2 oil level dipstick guide.

    3. Remove the O-ring from the No. 2 oil level dipstick guide.

  11. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH


    1. A01FEX7E01
      Text in Illustration
      *a Front

      Remove the 6 nuts, exhaust manifold sub-assembly RH and gasket.

  12. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH


    1. A01FIKJE01
      Text in Illustration
      *a Front

      Remove the 6 nuts, exhaust manifold sub-assembly LH and gasket.