INJECTOR DRIVER INSTALLATION


  1. INSTALL INJECTOR DRIVER

    Note


    • Be careful not to drop or strike the injector driver.

    • The injector driver is grounded at the bolt and nut. To ensure that it is grounded, clean all oil and foreign matter from the installation areas of the injector driver and engine before installing the injector driver.


    1. Install the injector driver with the bolt and 2 nuts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
    2. A01FF5JE01
      Text in Illustration
      *1 Lock Lever

      Connect the 4 connectors to the injector driver. Move the lock levers in the direction indicated by the arrow to lock the 3 connectors.

  2. INSTALL NO. 1 ENGINE COVER


    1. Install the No. 1 engine cover with the 3 clips.

  3. INSTALL NO. 1 AIR CLEANER INLET


    1. Install the No. 1 air cleaner inlet with the bolt.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  4. INSTALL V-BANK COVER SUB-ASSEMBLY


    1. A01FHZ4E01
      Text in Illustration
      *1 Tip (Round Portion)

      Attach the 3 clips in the order shown in the illustration to install the V-bank cover.

      Note


      • Securely attach the clips.

      • If the clips are forcibly attached or struck with an object, they may be damaged.

      • Do not apply any oil to the tips (round portions).

  5. INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 7 clips.

  6. INSTALL ENGINE ROOM SIDE COVER


    1. Install the engine room side cover with the 4 clips.

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.