FUEL PRESSURE PULSATION DAMPER INSTALLATION


  1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY


    1. Apply a light coat of engine oil to the threads and gasket seating surface of the fuel pressure pulsation damper assembly.

    2. Install 2 new gaskets, the fuel tube and fuel pressure pulsation damper to the fuel pump.

    3. A01FF8VE01
      Text in Illustration
      *1 Fuel Tube Sub-assembly

      Using SST, tighten the fuel pressure pulsation damper to the fuel pump.

      SST
      09922-10010
      Torque:
      without SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }
      with SST
      28 N*m  { 281 kgf*cm, 20 ft.*lbf }

      Tech Tips


      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.).


      • The torque shown above should be used for tightening without using SST. When SST is used for tightening, the torque should be calculated based on the length of SST Click here.

  2. INSTALL NO. 3 WATER BY-PASS PIPE


    1. Connect the 2 water by-pass hoses and install the No. 3 water by-pass pipe.

    2. Install the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    3. Attach the wire harness clamp to the No. 3 water by-pass pipe.

    4. Connect the 2 heater water hoses.

  3. INSTALL INTAKE AIR SURGE TANK ASSEMBLY

    Click here