COLD START INJECTOR INSTALLATION

INSTALL COLD START FUEL INJECTOR ASSEMBLY
1. Text in Illustration
  
  *1 Protrusion
  
  *2 Groove
  
  Install a new gasket to the intake air surge tank.
  
  Tech Tips
  
  Align the protrusion of the gasket with the groove on the intake air surge tank.
2. Install the cold start fuel injector with the 2 bolts.
  
  Torque:
  
  10 N*m { 102 kgf*cm, 7 ft.*lbf }
3. Install 2 new gaskets and the hose to the cold start fuel injector with the bolt.
  
  Torque:
  
  15 N*m { 153 kgf*cm, 11 ft.*lbf }
  Note
  - Be careful not to damage the gasket.
  - Do not fold or bend the hose.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSPECT FOR FUEL LEAK
1. Connect the GTS to the DLC3.
  1. Turn the engine switch on (IG).
    
    Note
    
    Do not start the engine.
  2. Turn the GTS on.
  3. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
2. Check the fuel pump operation.
  1. Check for pressure in the fuel inlet tube from the fuel line. Check that sound of fuel flowing in the fuel tank can be heard.
    
    If no sound can be heard, check the No. 1 integration relay, fuel pump, ECM and wiring connector.
3. Inspect for fuel leaks.
  1. Check that there are no fuel leaks anywhere on the system after performing maintenance.
    
    If there is a fuel leak, repair or replace parts as necessary.
INSTALL V-BANK COVER SUB-ASSEMBLY
1. Text in Illustration
  
  *1 Tip (Round Portion)
  
  Attach the 3 clips in the order shown in the illustration to install the V-bank cover.
  Note
  - Securely attach the clips.
  - If the clips are forcibly attached or struck with an object, they may be damaged.
  - Do not apply any oil to the tips (round portions).

Text in Illustration
*1	Protrusion
*2	Groove