COLD START INJECTOR REMOVAL


  1. DISCHARGE FUEL SYSTEM PRESSURE

    Click here

  2. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01FIO6E01

      Place one hand on the rear of the cover as shown in the illustration and detach the clip near the rear. Then, place both hands on the sides of the cover and lift the cover to detach the 2 clips near the front in the order shown in the illustration to remove the cover.

      Text in Illustration
      A01FE8R Areas to place hands when lifting cover

      Note

      If the cover is lifted rearward or forward and to the right or left at the same time, the cover maybe damaged.

  5. REMOVE COLD START FUEL INJECTOR ASSEMBLY


    1. Disconnect the cold start fuel injector connector.

    2. A01FH7W

      Remove the bolt and 2 gaskets, and disconnect the fuel tube from the cold start fuel injector.

      Note

      Do not fold or bend the hose.

    3. A01FIW8

      Remove the 2 bolts, gasket and cold start fuel injector assembly from the surge tank.