DRIVE BELT REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A01FGMK

      Remove the 4 clips and engine room side cover.

  2. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01FGF0

      Remove the 7 clips and cool air intake duct seal.

  3. REMOVE NO. 1 AIR CLEANER INLET


    1. A01FHG8

      Remove the bolt and No. 1 air cleaner inlet.

  4. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01FIO6E01

      Place one hand on the rear of the cover as shown in the illustration and detach the clip near the rear. Then, place both hands on the sides of the cover and lift the cover to detach the 2 clips near the front in the order shown in the illustration to remove the cover.

      Text in Illustration
      A01FE8R Areas to place hands when lifting cover

      Note

      If the cover is lifted rearward or forward and to the right or left at the same time, the cover maybe damaged.

  5. REMOVE FAN AND GENERATOR V BELT


    1. A01FIUU

      While releasing the belt tension by turning the belt tensioner counterclockwise, remove the V belt from the belt tensioner.

    2. A01FHWGE01

      While turning the belt tensioner counterclockwise, align its holes, and then insert the 5 mm bi-hexagon wrench into the holes to secure the belt tensioner.