REAR CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL REAR ENGINE OIL SEAL


    1. Apply MP grease to the lip of a new oil seal.

      Note

      Keep the lip free of foreign matter.

    2. A01FIDYE02

      Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )

      Note


      • Wipe off extra grease of the crankshaft.

      • Keep the lip free of foreign matter.

      • Do not tap on the oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A01FDLKE04

      Using SST, hold the crankshaft pulley.

      SST
      09213-70010   ( 09213-70020 )
      09330-00021

    2. Clean the 8 bolts and 8 bolt holes.

    3. A01FHO9E01
      Text in Illustration
      *1 Pin Hole
      *2 Pin

      Install the front drive plate spacer.

      Tech Tips

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

    4. A01FINAE03
      Text in Illustration
      *1 Drive Plate
      *2 Rear Drive Plate Spacer
      A01FGIV Transmission

      Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.

    5. Apply a few drops of adhesive to 2 or 3 threads of the 6 bolt tips.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    6. A01FHAXE01

      In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.

      Torque:
      83 N*m  { 846 kgf*cm, 61 ft.*lbf }

  3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

    Click here

  4. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that no oil leaks from the connection point of the oil filter cap.