REAR CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL REAR ENGINE OIL SEAL


    1. Apply MP grease to the lip of a new oil seal.

      Note

      Keep the lip free of foreign matter.

    2. A01FIDYE02

      Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )

      Note


      • Wipe off extra grease of the crankshaft.

      • Keep the lip free of foreign matter.

      • Do not tap on the oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A01FDLKE04

      Using SST, hold the crankshaft pulley.

      SST
      09213-70010   ( 09213-70020 )
      09330-00021

    2. Clean the 8 bolts and 8 bolt holes.

    3. A01FHO9E01
      Text in Illustration
      *1 Pin Hole
      *2 Pin

      Install the front drive plate spacer.

      Tech Tips

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

    4. A01FINAE03
      Text in Illustration
      *1 Drive Plate
      *2 Rear Drive Plate Spacer
      A01FGIV Transmission

      Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.

    5. Apply a few drops of adhesive to 2 or 3 threads of the 6 bolt tips.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    6. A01FHAXE01

      In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.

      Torque:
      83 N*m  { 846 kgf*cm, 61 ft.*lbf }

  3. INSTALL AUTOMATIC WITH TRANSFER TRANSMISSION ASSEMBLY (for AWD)

    Click here

  4. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for 2WD)

    Click here

  5. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that no oil leaks from the connection point of the oil filter cap.