FRONT CRANKSHAFT OIL SEAL REMOVAL


  1. REMOVE FAN SHROUD

    Click here

  2. REMOVE FAN AND GENERATOR V BELT


    1. A01FIUU

      While releasing the belt tension by turning the belt tensioner counterclockwise, remove the V belt from the belt tensioner.

    2. A01FHWGE01

      While turning the belt tensioner counterclockwise, align its holes, and then insert the 5 mm bi-hexagon wrench into the holes to secure the belt tensioner.

  3. DISCONNECT WIRE HARNESS (for 2WD)


    1. A01FIXJ

      Disconnect the engine oil pressure switch connector.

    2. Remove the bolt and disconnect the wire harness bracket.

  4. REMOVE CRANKSHAFT PULLEY


    1. A01FGZLE05
      Text in Illustration
      *a Hold
      *b Turn

      Using SST, loosen the pulley bolt.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021
    2. A01FI58E09
      Text in Illustration
      *a Hold
      *b Turn

      Tighten the pulley bolt to 2 or 3 threads of the crankshaft.

    3. Using SST, remove the pulley bolt and pulley.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

      Tech Tips

      Apply grease to the threads and tip of SST (center bolt) prior to use.

  5. REMOVE CRANKSHAFT TIMING GEAR KEY


    1. A01FGVD

      Remove the pulley set key of the key groove.

  6. REMOVE TIMING CHAIN CASE OIL SEAL


    1. A01FET5E02
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with its tip taped, pry out the oil seal.

      Tech Tips

      Tape the screwdriver tip before use.

      Note

      After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.