FRONT CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL TIMING CHAIN CASE OIL SEAL


    1. Apply MP grease to the lip of a new oil seal.

      Note

      Keep the lip free of foreign matter.

    2. A01FI9VE01

      Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain case edge.

      SST
      09223-22010
      09506-35010

      Note


      • Keep the lip free of foreign matter.

      • Do not tap the oil seal at an angle.

  2. INSTALL CRANKSHAFT TIMING GEAR KEY


    1. Install the pulley set key to the key groove.

  3. INSTALL CRANKSHAFT PULLEY


    1. A01FH2PE04
      Text in Illustration
      *a Hold
      *b Turn

      Align the pulley set key with the key groove of the pulley, and slide on the pulley.

    2. Using SST, install the crankshaft pulley bolt.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021
      Torque:
      250 N*m  { 2549 kgf*cm, 184 ft.*lbf }

  4. CONNECT WIRE HARNESS (for 2WD)


    1. Install the wire harness bracket with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    2. Connect the engine oil pressure switch connector.

  5. INSTALL FAN AND GENERATOR V BELT


    1. A01FFUOE03
      Text in Illustration
      *1 Engine Water Pump
      *2 Generator
      *3 Idler
      *4 Tensioner
      *5 Crankshaft
      *6 A/C Compressor

      Set the V belt onto every part.

    2. While turning the belt tensioner counterclockwise, remove the bar.

      Note


      • Put the backside of the V belt on the tensioner pulley and idler pulley.

      • Check that the V belt is properly set to each pulley.

    3. If it is difficult to install the V belt, perform the following procedure.


      1. Put the V belt on every part except the tensioner pulley.

      2. Put the V belt on the tensioner pulley while turning the belt tensioner counterclockwise.

        Note


        • Put the backside of the V belt on the tensioner pulley and idler pulley.

        • Check that the V belt is properly set to each pulley.

    4. Check that the belt fits properly in the ribbed grooves.

      Tech Tips

      Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

  6. INSTALL FAN SHROUD

    Click here

  7. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that no oil leaks from the connection point of the oil filter cap.