DRIVE BELT INSTALLATION


  1. INSTALL FAN AND GENERATOR V BELT


    1. A01FFUOE03
      Text in Illustration
      *1 Engine Water Pump
      *2 Generator
      *3 Idler
      *4 Tensioner
      *5 Crankshaft
      *6 A/C Compressor

      Set the V belt onto every part.

    2. While turning the belt tensioner counterclockwise, remove the bar.

      Note


      • Put the backside of the V belt on the tensioner pulley and idler pulley.

      • Check that the V belt is properly set to each pulley.

    3. If it is difficult to install the V belt, perform the following procedure.


      1. Put the V belt on every part except the tensioner pulley.

      2. Put the V belt on the tensioner pulley while turning the belt tensioner counterclockwise.

        Note


        • Put the backside of the V belt on the tensioner pulley and idler pulley.

        • Check that the V belt is properly set to each pulley.

    4. Check that the belt fits properly in the ribbed grooves.

      Tech Tips

      Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

  2. INSTALL V-BANK COVER SUB-ASSEMBLY


    1. A01FGFXE01
      Text in Illustration
      *1 Tip (Round Portion)

      Attach the 3 clips in the order shown in the illustration to install the V-bank cover.

      Note


      • Securely attach the clips.

      • If the clips are forcibly attached or struck with an object, they may be damaged.

      • Do not apply any oil to the tips (round portions).

  3. INSTALL NO. 1 AIR CLEANER INLET


    1. Install the No. 1 air cleaner inlet with the bolt.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  4. INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 7 clips.

  5. INSTALL ENGINE ROOM SIDE COVER


    1. Install the engine room side cover with the 4 clips.