CAMSHAFT POSITION SENSOR REMOVAL


  1. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01FIO6E01

      Place one hand on the rear of the cover as shown in the illustration and detach the clip near the rear. Then, place both hands on the sides of the cover and lift the cover to detach the 2 clips near the front in the order shown in the illustration to remove the cover.

      Text in Illustration
      A01FE8R Areas to place hands when lifting cover

      Note

      If the cover is lifted rearward or forward and to the right or left at the same time, the cover maybe damaged.

  2. REMOVE VVT SENSOR (for Intake Side of Bank 1)


    1. A01FJ0Q

      Disconnect the VVT sensor connector.

    2. Remove the bolt and VVT sensor.

  3. REMOVE VVT SENSOR (for Exhaust Side of Bank 1)


    1. A01FHON

      Disconnect the VVT sensor connector.

    2. Remove the bolt and VVT sensor.

  4. REMOVE VVT SENSOR (for Intake Side of Bank 2)


    1. A01FHT5

      Disconnect the VVT sensor connector.

    2. Remove the bolt and VVT sensor.

  5. REMOVE VVT SENSOR (for Exhaust Side of Bank 2)


    1. A01FI0Q

      Disconnect the VVT sensor connector.

    2. Remove the bolt and VVT sensor.