IGNITION COIL AND SPARK PLUG INSTALLATION

Tech Tips

w/ Canister Pump Module:

Perform "Inspection After Repairs" after replacing the ignition coil or the spark plug Click here.


  1. INSTALL SPARK PLUG

    Tech Tips

    w/ Canister Pump Module:

    Perform "Inspection After Repairs" after replacing the spark plug Click here.


    1. Install the 6 spark plugs.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

  2. INSTALL IGNITION COIL ASSEMBLY

    Tech Tips

    w/ Canister Pump Module:

    Perform "Inspection After Repairs" after replacing the ignition coil Click here.


    1. Install the 6 ignition coils with the 6 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    2. Connect the 6 ignition coil connectors.

    3. A01FGA6E01

      Connect the 2 wire harness brackets with the 2 bolts.

      Torque:
      for bolt A
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }
      for bolt B
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    4. Connect the wire harness clamp.

    5. Connect the wire harness with the 2 nuts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  3. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. A01FIUS

      Install the air cleaner cap with air cleaner hose assembly with the 4 clamps and hose clamp.

      Torque:
      4.0 N*m  { 41 kgf*cm, 35 in.*lbf }

      Tech Tips

      Fit the protrusion on the air cleaner hose into the hole of the hose clamp on the throttle valve side.

    2. Connect the VSV hose to the air cleaner hose.

    3. for RHD:

      Connect the union to check valve hose.

    4. Connect the mass air flow meter connector and clamp to the air cleaner.

  4. INSTALL NO. 2 VENTILATION HOSE


    1. A01FIWDE01
      Text in Illustration
      *1 Paint Mark
      *a Top
      *b Front

      Connect the ventilation hose to the cylinder head cover with the clamp.

      Tech Tips

      Make sure the direction of the clip is as shown in the illustration.

  5. INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 7 clips.

  6. INSTALL ENGINE ROOM SIDE COVER


    1. Install the engine room side cover with the 4 clips.

  7. INSTALL V-BANK COVER SUB-ASSEMBLY


    1. A01FGFXE01
      Text in Illustration
      *1 Tip (Round Portion)

      Attach the 3 clips in the order shown in the illustration to install the V-bank cover.

      Note


      • Securely attach the clips.

      • If the clips are forcibly attached or struck with an object, they may be damaged.

      • Do not apply any oil to the tips (round portions).