IGNITION COIL AND SPARK PLUG REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A01FGMK

      Remove the 4 clips and engine room side cover.

  2. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01FGF0

      Remove the 7 clips and cool air intake duct seal.

  3. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01FFEFE01

      Place both hands on the sides of the cover as shown in the illustration, lift the cover to detach the 2 clips near the front in the order shown in the illustration, and then lift the cover further to detach the rear clip and remove the cover.

      Text in Illustration
      A01FE8R Areas to place hands when lifting cover

      Note

      If the cover is lifted rearward or forward and to the right or left at the same time, the cover maybe damaged.

  4. DISCONNECT NO. 2 VENTILATION HOSE


    1. A01FI2N

      Disconnect the ventilation hose from the cylinder head.

  5. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. A01FEMK

      Disconnect the mass air flow meter connector.

    2. Disconnect the clamp from the air cleaner.

    3. A01FDGM

      Disconnect the VSV hose.

    4. A01FDVX

      for RHD:

      Disconnect the union to check valve hose.

    5. A01FF3K

      Disconnect the 4 clamps.

    6. Remove the hose clamp and air cleaner cap with air cleaner hose.

  6. REMOVE IGNITION COIL ASSEMBLY


    1. A01FDP5

      Remove the 2 nuts and disconnect the wire harness.

    2. A01FGA6

      Disconnect the wire harness clamp.

    3. Remove the 2 bolts and disconnect the 2 wire harness brackets.

    4. Disconnect the 6 ignition coil connectors.

    5. A01FDCG

      Remove the 6 bolts and the 6 ignition coil assemblies.

  7. REMOVE SPARK PLUG


    1. Remove the 6 spark plugs.