CAMSHAFT POSITION SENSOR REMOVAL


  1. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01FFEFE01

      Place both hands on the sides of the cover as shown in the illustration, lift the cover to detach the 2 clips near the front in the order shown in the illustration, and then lift the cover further to detach the rear clip and remove the cover.

      Text in Illustration
      A01FE8R Areas to place hands when lifting cover

      Note

      If the cover is lifted rearward or forward and to the right or left at the same time, the cover maybe damaged.

  2. REMOVE VVT SENSOR (for Intake Side of Bank 1)


    1. A01FE11

      Disconnect the VVT sensor connector.

    2. Remove the bolt and VVT sensor.

  3. REMOVE VVT SENSOR (for Exhaust Side of Bank 1)


    1. A01FHVM

      Disconnect the VVT sensor connector.

    2. Remove the bolt and VVT sensor.

  4. REMOVE VVT SENSOR (for Intake Side of Bank 2)


    1. A01FI98

      Disconnect the VVT sensor connector.

    2. Remove the bolt and VVT sensor.

  5. REMOVE VVT SENSOR (for Exhaust Side of Bank 2)


    1. A01FH44

      Disconnect the VVT sensor connector.

    2. Remove the bolt and VVT sensor.