ECM INSTALLATION


  1. INSTALL NO. 2 ECM BRACKET


    1. Install the No. 2 ECM bracket with the 2 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

  2. INSTALL ECM BRACKET


    1. Install the ECM bracket with the 2 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

  3. INSTALL ECM


    1. Install the ECM with the 2 nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      Note


      • Install the ECM to the ECM box with the name plate facing the outside of the vehicle.

      • Make sure that there is no foreign matter on the gasket surface of the ECM box.

      • Insert the stud bolt on the vehicle rear side to the ECM first.

      • Make sure that stud bolts are securely installed into the front and rear bolt holes.

  4. CONNECT WIRE HARNESS


    1. Connect the 6 ECM connectors.

      Note

      Be sure to securely connect the connector.

    2. Connect the connector holder to the ECM box.

    3. Connect the junction connector to the connector holder.

    4. Connect the 2 connectors.

  5. INSTALL ECM COVER


    1. Install the ECM cover with the 3 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      Note

      Make sure that the wire harness does not get caught between the parts.

  6. INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 7 clips.

  7. INSTALL ENGINE ROOM SIDE COVER


    1. Install the engine room side cover with the 4 clips.

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. PERFORM INITIALIZATION

    Click here