ECM REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE ENGINE ROOM SIDE COVER


    1. A01FGMK

      Remove the 4 clips and engine room side cover.

  4. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01FGF0

      Remove the 7 clips and cool air intake duct seal.

  5. REMOVE ECM COVER


    1. A01FHIK

      Remove the 3 bolts and ECM cover.

      Note


      • Remove all water on and around the ECM cover.

      • Perform the inspection indoors to avoid rain.

      • Be sure to prevent water intrusion to the ECM (connectors and screw parts).

  6. DISCONNECT WIRE HARNESS


    1. A01FIDC

      Disconnect the 2 connectors from the connector holder.

    2. Disconnect the junction connector from the connector holder.

    3. A01FER5

      Using a screwdriver, disconnect the connector holder.

    4. A01FEH4

      Disconnect the 6 ECM connectors.

  7. REMOVE ECM


    1. A01FDCS

      Remove the 2 nuts and ECM.

  8. REMOVE ECM BRACKET


    1. A01FHVU

      Remove the 2 screws and ECM bracket.

  9. REMOVE NO. 2 ECM BRACKET


    1. A01FD8I

      Remove the 2 screws and No. 2 ECM bracket.