TIRE PRESSURE WARNING INITIATOR DRIVER (for LHD) INSTALLATION


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

  2. INSTALL TIRE PRESSURE MONITOR INITIATOR DRIVER


    1. Attach the 2 claws to install the tire pressure monitor initiator driver.

  3. INSTALL ECU INTEGRATION BOX RH


    1. Install the ECU integration box RH with the 2 nuts and bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    2. Attach the clamp.

    3. Connect all the connectors.

      Note


      • Do not twist the connectors of the ECUs when connecting them.

      • Do not apply more force than necessary to the connectors. If more than 98 N (10 kgf, 22 lbf) of force is applied to a connector, the connector or connector holder may be damaged.

  4. INSTALL COWL SIDE JUNCTION BLOCK RH


    1. Install the cowl side junction block RH to the reinforcement with the bolt and nut.

    2. Connect the connector.

    3. w/o VGRS System:


      1. Attach the clamp.

      2. Connect the connector.

    4. for AWD:


      1. Attach the clamp.

      2. Connect the 2 connectors.

    5. w/ VGRS System:


      1. Attach the 2 clamps.

      2. Connect the 5 connectors.

  5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

    A01FDK7E01
    Text in Illustration
    *1 Screw <A>
    *2 Bolt <E>

    1. Connect the connectors and attach the clamp.

    2. Attach the 6 clips to install the glove compartment door assembly.

    3. Install the 3 screws <A> and 2 bolts <E>.

  6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Connect the connectors and attach the clamp.

    2. Attach the 5 clips and 2 guides to install the No. 2 instrument panel under cover sub-assembly.

  7. INSTALL INSTRUMENT SIDE PANEL RH


    1. w/ Airbag Cut Off Switch:


      1. Connect the connector.

    2. Attach the 7 clips to install the instrument side panel RH.

  8. INSTALL FRONT DOOR OPENING TRIM COVER RH

    Tech Tips

    Use the same procedure described for the LH side.

  9. INSTALL FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure described for the LH side.

  10. INSTALL INSTRUMENT PANEL FINISH PANEL END RH


    1. Attach the 5 clips and 2 guides to install the instrument panel finish panel end RH.

  11. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL


    1. Connect the connector.

    2. Attach the 9 clips and guide to install the center instrument cluster finish panel.

  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  13. CHECK SRS WARNING LIGHT

    Click here

  14. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here