FRONT ACCELERATION SENSOR INSTALLATION


  1. INSTALL FRONT ACCELERATION SENSOR ASSEMBLY


    1. Install the front acceleration sensor assembly with the 2 nuts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Do not drop the sensor. If it is dropped, replace it with a new one.

      • The acceleration sensor must not be placed upside down.

    2. Connect the connector.

    3. Return the floor carpet to its original position.

  2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)


    1. Connect the connectors and attach the clamp.

    2. Attach the 2 claws to install the No. 1 instrument panel under cover sub-assembly.

    3. Install the 3 screws <A>.

  3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)


    1. Connect the connectors and attach the clamp.

    2. Attach the 5 clips and 2 guides to install the No. 2 instrument panel under cover sub-assembly.

  4. INSTALL FRONT DOOR OPENING TRIM COVER LH


    1. Attach the 5 claws to install the front door opening trim cover LH.

      Note

      After installing the front door opening trim cover LH, make sure that the lip of the front door opening trim weatherstrip LH is not pinched.

  5. INSTALL FRONT DOOR SCUFF PLATE LH


    1. Attach the 10 claws and 4 clips to install the front door scuff plate LH.

  6. INSTALL INSTRUMENT SIDE PANEL LH


    1. Attach the 7 clips to install the instrument side panel LH.

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. INSPECT ADAPTIVE VARIABLE SUSPENSION SYSTEM

    Click here