FRONT ACCELERATION SENSOR REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE INSTRUMENT SIDE PANEL LH

    A01FFR7E01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument side panel LH.

    2. Using a moulding remover, detach the 7 clips and remove the instrument side panel LH.

  4. REMOVE FRONT DOOR SCUFF PLATE LH


    1. Place your hands on the inner portion of the front door scuff plate LH and detach the 2 claws labeled A, 6 claws labeled B and 2 claws labeled C in the order shown in the illustration.

    2. Raise the front door scuff plate LH to detach the 4 clips on the outer side and remove it.

      A01FFCRE01
      Text in Illustration
      *1 Claw A *2 Claw B
      *3 Claw C - -

  5. REMOVE FRONT DOOR OPENING TRIM COVER LH

    A01FHVP

    1. Detach the 5 claws and remove the front door opening trim cover LH.

  6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

    A01FH83

    1. Remove the 3 screws <A>.

    2. Detach the 2 claws.

    3. Disconnect the connectors, detach the clamp and remove the No. 1 instrument panel under cover sub-assembly.

  7. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

    A01FE9H

    1. Detach the 5 clips and 2 guides.

    2. Disconnect the connectors, detach the clamp and remove the No. 2 instrument panel under cover sub-assembly.

  8. REMOVE FRONT ACCELERATION SENSOR ASSEMBLY


    1. Fold back the floor carpet.

    2. A01FI2L

      Disconnect the connector.

    3. Remove the 2 nuts and front acceleration sensor assembly.