SUSPENSION CONTROL ECU INSTALLATION


  1. INSTALL ABSORBER CONTROL ECU


    1. Install the absorber control ECU with the bolt and nut.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Avoid any impact to the absorber control ECU.

      • Do not drop the absorber control ECU. If it is dropped, replace it with a new one.

    2. Connect the 3 connectors.

    3. Return the floor carpet to its original position.

  2. INSTALL FRONT DOOR OPENING TRIM COVER RH

    Tech Tips

    Use the same procedure described for the LH side.

  3. INSTALL FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure described for the LH side.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note


    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    • After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode Click here.