REAR ACCELERATION SENSOR REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER INNER RH

    Click here

  4. REMOVE REAR ACCELERATION SENSOR ASSEMBLY


    1. A01FIVH

      Disconnect the connector.

    2. Remove the bolt and rear acceleration sensor.

      Note


      • Do not drop the rear acceleration sensor. If it is dropped, replace it with a new one.

      • The rear acceleration sensor must not be placed upside down.