REAR DIFFERENTIAL CARRIER ASSEMBLY (for 4GR-FSE) INSTALLATION


  1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

    A01FEYCE01

    1. Using a hexagon wrench (12 mm), temporarily install the differential carrier to the suspension member with 3 new bolts (A).

    2. Install the 2 rear upper differential mount stoppers and 2 rear lower differential mount stoppers.

    3. Temporarily install the differential carrier rear to the suspension member with 2 new bolts (B).

    4. Using a 12 mm hexagon wrench and torque wrench, tighten the 3 bolts (A) to the specified torque.

      Torque:
      103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

    5. Using a torque wrench, tighten the 2 bolts (B) to the specified torque.

      Torque:
      95 N*m  { 969 kgf*cm, 70 ft.*lbf }

      Note

      Do not tilt the inner tube or rubber parts when tightening the differential mount stopper.

  2. INSTALL REAR SUSPENSION MEMBER

    Click here

  3. INSTALL PARKING BRAKE WITH BRACKET ACTUATOR ASSEMBLY

    Click here

  4. INSTALL PROPELLER SHAFT WITH CENTER BEARING

    Click here

  5. INSTALL REAR DRIVE SHAFT ASSEMBLY LH

    Click here

  6. INSTALL REAR DRIVE SHAFT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  7. ADJUST PARKING BRAKE

    Click here

  8. ADD DIFFERENTIAL OIL


    1. A01FGI8E51
      Text in Illustration
      *a 0 to 5 mm (0 to 0.196 in.)

      Add differential oil so that the oil level is within 5 mm (0 to 0.196 in.) of the bottom lip of the differential filler plug hole.

      Note


      • Too much or too little oil will lead to differential problems.

      • After changing the oil, drive the vehicle and then check the oil level again.

    2. for Front Differential:

      Oil type
      Hypoid gear oil API GL-5 or equivalent
      Recommended Viscosity
      Temperature Viscosity
      Above -18°C (0°F) SAE 90
      Below -18°C (0°F) SAE 80W or 80W-90
      Standard Differential Oil Capacity
      0.65 to 0.75 liters (0.69 to 0.79 US qts, 0.58 to 0.66 Imp. qts)

      1. Using a 10 mm hexagon wrench, install a new gasket and the filler plug.

        Torque:
        39 N*m  { 400 kgf*cm, 29 ft.*lbf }

      2. Install the engine under cover.

    3. for Rear Differential:

      Oil type and viscosity
      Toyota genuine differential gear oil LT 75W-85 GL-5 or equivalent
      Standard Differential Oil Capacity
      Engine Specified Condition
      2GR-FSE 1.30 to 1.40 liters (1.38 to 1.47 US qts, 1.15 to 1.23 Imp. qts)
      4GR-FSE 1.10 to 1.20 liters (1.17 to 1.26 US qts, 0.97 to 1.05 Imp. qts)

      1. Install a new gasket and the filler plug.

        Torque:
        49 N*m  { 500 kgf*cm, 36 ft.*lbf }

  9. INSTALL REAR WHEELS

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }