FRONT DIFFERENTIAL CARRIER ASSEMBLY (for AWD) INSTALLATION


  1. INSTALL FRONT DIFFERENTIAL CARRIER ASSEMBLY


    1. Support the differential carrier assembly with a jack. Temporarily install the differential carrier assembly to the engine assembly with the 3 bolts.

    2. Tighten the 3 bolts to install the differential carrier assembly.

      Torque:
      87 N*m  { 890 kgf*cm, 64 ft.*lbf }

  2. INSTALL ENGINE ASSEMBLY

    Click here

  3. ADD DIFFERENTIAL OIL


    1. A01FGI8E51
      Text in Illustration
      *a 0 to 5 mm (0 to 0.196 in.)

      Add differential oil so that the oil level is within 5 mm (0 to 0.196 in.) of the bottom lip of the differential filler plug hole.

      Note


      • Too much or too little oil will lead to differential problems.

      • After changing the oil, drive the vehicle and then check the oil level again.

    2. for Front Differential:

      Oil type
      Hypoid gear oil API GL-5 or equivalent
      Recommended Viscosity
      Temperature Viscosity
      Above -18°C (0°F) SAE 90
      Below -18°C (0°F) SAE 80W or 80W-90
      Standard Differential Oil Capacity
      0.65 to 0.75 liters (0.69 to 0.79 US qts, 0.58 to 0.66 Imp. qts)

      1. Using a 10 mm hexagon wrench, install a new gasket and the filler plug.

        Torque:
        39 N*m  { 400 kgf*cm, 29 ft.*lbf }

      2. Install the engine under cover.

    3. for Rear Differential:

      Oil type and viscosity
      Toyota genuine differential gear oil LT 75W-85 GL-5 or equivalent
      Standard Differential Oil Capacity
      Engine Specified Condition
      2GR-FSE 1.30 to 1.40 liters (1.38 to 1.47 US qts, 1.15 to 1.23 Imp. qts)
      4GR-FSE 1.10 to 1.20 liters (1.17 to 1.26 US qts, 0.97 to 1.05 Imp. qts)

      1. Install a new gasket and the filler plug.

        Torque:
        49 N*m  { 500 kgf*cm, 36 ft.*lbf }