ADAPTIVE VARIABLE SUSPENSION SYSTEM OPERATION CHECK


  1. CHECK ABSORBER CONTROL ACTUATOR OPERATION


    1. A01FFIJE22

      Using SST, connect the terminals 12 (TS) and 4 (CG) of the DLC3.

      SST
      09843-18040

    2. Turn the engine switch on (IG).

    3. A01FHQLE01
      Text in Illustration
      *a Blinking Pattern in Test Mode
      *b 0.125 Seconds

      Check that the "SPORT S+" indicator in the multi-information display is blinking in the Test Mode blinking pattern.

      Tech Tips

      If the "SPORT S+" indicator in the multi-information display does not blink, inspect the "SPORT S+" indicator Click here.

    4. A01FIK1E02
      Text in Illustration
      *a Shift Range
      *b 15°
      *c 120°
      *d SOFT
      *e HARD

      Check absorber control actuator operation.

      Starting from the SOFT position, depress the brake pedal. Using GTS, check that the absorber control actuator position increases by 2 steps each time the brake pedal is depressed (1 (SOFT) → 3 → 5 → 7 → 9 → 11 → 15 → 17 (HARD)). At this time, bounce the vehicle and check that the shock absorber is becoming harder.

      Tech Tips


      • Every time the brake pedal is depressed, the absorber control actuator rotates in the hard to soft direction in 15° intervals up to a maximum angle of 120°.

      • If the absorber control actuator does not operate, inspect the absorber control actuator circuit and absorber control actuator installation condition.

      Trouble Area See procedure
      Absorber control actuator circuit

      Click here

      Front absorber control actuator installation condition

      Click here

      Rear absorber control actuator installation condition

      Click here

    5. Turn the engine switch off.

    6. Disconnect SST from terminals 12 (TS) and 4 (CG) of the DLC3.

    7. Turn the engine switch on (IG).

      Tech Tips

      If the engine switch remains on (IG) after SST is removed from DLC3, the vehicle will remain in the previously initialized Test Mode.