PROPELLER SHAFT ASSEMBLY (for 4GR-FSE) REMOVAL


  1. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here

  2. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR


    1. A01FFA3

      Remove the 4 nuts and front No. 1 floor heat insulator.

  3. REMOVE NO. 1 FUEL TANK PROTECTOR


    1. A01FIHE

      Remove the 4 nuts and No. 1 fuel tank protector.

  4. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY


    1. A01FIAAE01
      Text in Illustration
      *a Matchmark

      Put matchmarks on the propeller shaft flange and differential flange.

    2. Remove the 4 nuts, 4 bolts and 4 washers and disconnect the propeller shaft.

      Tech Tips

      If the flange connection is hard to separate, temporarily install 1 nut only and evenly tap the flange with a brass bar and hammer to separate the propeller shaft assembly from the differential companion flange.

    3. A01FHEK

      Remove the 2 bolts and 2 washers.

      Tech Tips

      Some vehicles are not equipped with the washers.

    4. Pull out the propeller shaft.

    5. A01FI13E01

      Insert SST in the transmission to prevent oil leakage.

      SST
      09325-40010

      Note

      Be careful not to damage the oil seal.