PARK / NEUTRAL POSITION SWITCH ADJUSTMENT


  1. DISCONNECT TRANSMISSION CONTROL SHAFT LEVER RH


    1. Move the shift lever to N.

    2. Remove the nut and spring washer, and separate the transmission control shaft lever RH from the park/neutral position switch assembly.

  2. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. A01FE9LE28
      Text in Illustration
      *a Neutral Basic Line
      *b Groove

      Remove the bolt from the park/neutral position switch assembly.

    2. Clean the bolt and the bolt hole.

    3. Align the neutral basic line with the groove as shown in the illustration.

    4. Apply adhesive to 2 or 3 threads on the end of the bolt.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    5. Hold the park/neutral position switch assembly in that position and tighten the bolt.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

  3. CONNECT TRANSMISSION CONTROL SHAFT LEVER RH


    1. Connect the transmission control shaft lever RH to the park/neutral position switch assembly with the spring washer and nut.

      Torque:
      16 N*m  { 160 kgf*cm, 12 ft.*lbf }

  4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    Click here