FRONT BUMPER REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01ETQR

      Remove the 9 clips and cool air intake duct seal.

  2. REMOVE FRONT BUMPER ASSEMBLY


    1. A01EXVV

      Apply protective tape around the front bumper assembly as shown in the illustration.

      Text in Illustration
      A01EVDL Protective Tape
    2. A01EURZ

      Remove the 8 screws.

    3. A01EY4LE01
      Text in Illustration
      *1 Pin Hold Clip
      *a 90°

      Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. Remove the clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    5. A01EVHH

      Disengage the 3 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    6. Pull back the side of the front bumper assembly and disconnect each connector.

      Note

      Do not apply excessive force when pulling back the front bumper assembly.

    7. A01ESUO

      Remove the bolt and 2 screws.

    8. Remove the 2 clips.

    9. w/ Headlight Cleaner System:


      1. A01EYXQ

        Disconnect the headlight cleaner hose and drain the washer fluid.

        Tech Tips

        Use a container to collect the washer fluid.

    10. Remove the front bumper assembly.