HEIGHT CONTROL SENSOR INSTALLATION


  1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY


    1. A01EYHKE01

      Install the rear height control sensor sub-assembly with the 3 nuts.

      Torque:
      Nut <A>
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
      Nut <B>
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    2. Connect the connector.

  2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. INITIALIZE HEIGHT CONTROL SENSOR SIGNAL

    for AFS (Adaptive Front-Lighting System) : Click here

    for Automatic Headlight Beam Level Control System: Click here

  4. ADJUST HEADLIGHT AIMING

    Click here