AFS OFF SWITCH REMOVAL


  1. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)


    1. Disable the auto away/return function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the auto away/return function is enabled or disabled) in order to restore the current setting after finishing this operation.

    2. Turn the ignition switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

  2. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    1. A01ET1F

      Disconnect the front door opening trim weatherstrip LH.

  3. REMOVE INSTRUMENT SIDE PANEL


    1. A01EWTC

      Using a moulding remover, disengage the 4 claws as shown in the illustration.

    2. A01EW81

      Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.

  4. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. A01EVO4

      Disengage the 4 clips to remove the No. 1 instrument panel register assembly as shown in the illustration.

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    1. for Manual Tilt and Manual Telescopic Steering Column:


      1. Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.

    2. A01ETIQ

      Using a moulding remover, disengage the 4 clips and 2 guides.

    3. for LHD:


      1. A01EXO3

        Disengage the 3 claws, 7 clips and 4 guides.

    4. for RHD:


      1. A01EUS4

        Disengage the 4 claws, 5 clips and 4 guides as shown in the illustration.

    5. Disconnect each connector.

    6. A01ESV8

      Remove the instrument cluster finish panel assembly as shown in the illustration.

  6. REMOVE HEADLIGHT SWIVEL MAIN SWITCH (AFS OFF SWITCH)


    1. A01EU8S

      Disengage the 2 claws and remove the headlight swivel main switch (AFS OFF switch).