REAR COMBINATION LIGHT ASSEMBLY ON-VEHICLE INSPECTION


  1. INSPECT REAR COMBINATION LIGHT ASSEMBLY LH


    1. A01EWRNE01
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Rear Combination Light Assembly LH)

      Disconnect the connector from the rear combination light assembly LH.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      T8-1 (B) - T8-2 (E) Turn signal switch in neutral position Below 1 V
      Turn signal switch in left turn position 11 to 14 V (60 to 120 times per minute)
      T9-2 (TL) - T9-1 (E) Light control switch off Below 1 V
      Light control switch in tail position 11 to 14 V
      T9-3 (STP) - T9-1 (E) Brake pedal released Below 1 V
      Brake pedal depressed 11 to 14 V

      If the result is not as specified, repair or replace the wire harness or connector.

  2. INSPECT REAR COMBINATION LIGHT ASSEMBLY RH


    1. A01EWRNE02
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Rear Combination Light Assembly RH)

      Disconnect the connector from the rear combination light assembly RH.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      T13-1 (B) - T13-2 (E) Turn signal switch in neutral position Below 1 V
      Turn signal switch in right turn position 11 to 14 V (60 to 120 times per minute)
      T12-2 (TL) - T12-1 (E) Light control switch off Below 1 V
      Light control switch in tail position 11 to 14 V
      T12-3 (STP) - T12-1 (E) Brake pedal released Below 1 V
      Brake pedal depressed 11 to 14 V

      If the result is not as specified, repair or replace the wire harness or connector.