AFS (ADAPTIVE FRONT-LIGHTING SYSTEM), Diagnostic DTC:B2417, B2418

DTC Code DTC Name
B2417 Headlight Beam Level Control Motor LH Malfunction
B2418 Headlight Beam Level Control Motor RH Malfunction

DESCRIPTION

The headlight leveling motor receives operation signals from the AFS ECU (headlight swivel ECU assembly). The AFS ECU (headlight swivel ECU assembly) receives signals indicating the operating conditions of the headlight leveling motor.

DTC No. DTC Detection Condition Trouble Area
B2417
  • Malfunction in headlight leveling motor LH

  • Open or short in headlight leveling motor LH circuit


  • Headlight leveling motor LH

  • Harness or connector

  • AFS ECU (headlight swivel ECU assembly)

B2418
  • Malfunction in headlight leveling motor RH

  • Open or short in headlight leveling motor RH circuit


  • Headlight leveling motor RH

  • Harness or connector

  • AFS ECU (headlight swivel ECU assembly)

WIRING DIAGRAM

A01EY34E01

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK FOR DTC


    1. Clear the DTCs Click here.

    2. Check for DTCs Click here.

      OK
      DTC B2417 or B2418 is not output.

    NG
    OK
  2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER


    1. Connect the intelligent tester to the DLC3.

    2. Start the engine.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / AFS / Active Test.

    5. Check that the leveling motors operate.

      AFS
      Tester Display Test Part Control Range Diagnostic Note
      Drive The Leveling Motor UP Leveling motor upward operation ON/OFF

      ON: Moves up

      OFF: Stops

      Drive The Leveling Motor DOWN Leveling motor downward operation ON/OFF

      ON: Moves down

      OFF: Stops

      OK
      Headlight leveling motors operate normally.

    NG
    OK
  3. CHECK HEADLIGHT LEVELING MOTOR


    1. Replace the headlight leveling motor with a new or a known good one Click here.

    2. Check for DTCs Click here.

      Tech Tips

      DTC B2417 or B2418 is stored when the AFS ECU (headlight swivel ECU assembly) receives a signal indicating an abnormality from a headlight leveling motor. It is not possible to judge whether a headlight leveling motor is normal using an Active Test, because even if the motor operates normally during the Active Test, it may still output a signal indicating an abnormality.

      OK
      DTC B2417 or B2418 is not output.

    NG
    OK
  4. CHECK HARNESS AND CONNECTOR (BATTERY - AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY))


    1. A01ESPGE41
      Text in Illustration
      *a

      Front view of wire harness connector

      (to AFS ECU (Headlight Swivel ECU Assembly))

      Disconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      A35-15 (IG) - Body ground Ignition switch ON 11 to 14 V

    NG
    OK
  5. CHECK HARNESS AND CONNECTOR (AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) - BODY GROUND)


    1. A01ESPGE40
      Text in Illustration
      *a

      Front view of wire harness connector

      (to AFS ECU (Headlight Swivel ECU Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A35-22 (E1) - Body ground Always Below 1 Ω

    NG
    OK
  6. CHECK HARNESS AND CONNECTOR (AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) - HEADLIGHT LEVELING MOTOR)


    1. Disconnect the LH side or RH side headlight leveling motor connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      LH Side (B2417)
      Tester Connection Condition Specified Condition
      A35-3 (LH+) - A19-1 (LHB1) Always Below 1 Ω
      A35-27 (LH-) - A19-3 (LHE) Always Below 1 Ω
      A35-30 (LHE) - A19-2 (LHM+) Always Below 1 Ω
      A35-3 (LH+) - Body ground Always 10 kΩ or higher
      A35-27 (LH-) - Body ground Always 10 kΩ or higher
      A35-30 (LHE) - Body ground Always 10 kΩ or higher
      RH Side (B2418)
      Tester Connection Condition Specified Condition
      A35-4 (RH+) - A61-1 (RHB1) Always Below 1 Ω
      A35-28 (RH-) - A61-3 (RHE) Always Below 1 Ω
      A35-11 (RHE) - A61-2 (RHM+) Always Below 1 Ω
      A35-4 (RH+) - Body ground Always 10 kΩ or higher
      A35-28 (RH-) - Body ground Always 10 kΩ or higher
      A35-11 (RHE) - Body ground Always 10 kΩ or higher

    NG
    OK
  7. INSPECT AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY)


    1. A01EY80E11
      Text in Illustration
      *a

      Component with harness connected

      (AFS ECU (Headlight Swivel ECU Assembly))

      Reconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      LH Side (B2417)
      Tester Connection Condition Specified Condition
      A35-3 (LH+) - A35-27 (LH-) Ignition switch off Below 1 V
      Ignition switch ON 11 to 14 V
      RH Side (B2418)
      Tester Connection Condition Specified Condition
      A35-4 (RH+) - A35-28 (RH-) Ignition switch off Below 1 V
      Ignition switch ON 11 to 14 V

    NG
    OK
  8. CHECK HEADLIGHT LEVELING MOTOR


    1. Replace the headlight leveling motor with a new or a known good one Click here.

    2. Check for DTCs Click here.

      OK
      DTC B2417 or B2418 is not output.

    NG
    OK