METER / GAUGE SYSTEM ON-VEHICLE INSPECTION


  1. INSPECT COMBINATION METER ASSEMBLY


    1. INSPECT SPEEDOMETER

      Note


      • The meter ECU receives the vehicle speed signal from the skid control ECU via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the skid control ECU because it is the source of the vehicle speed signal.

      • The Data List values of the skid control ECU are used for this inspection. Therefore, make sure to perform the inspection after confirming that no DTCs are output from the brake control system.

      • If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform the inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.


      1. Before starting the following inspection, check if the brake control system outputs the DTCs.

      2. Check the values by referring to the table below.

        ABS/VSC/TRC
        Tester Display Measurement Item/Range Normal Condition Diagnostic Note
        Vehicle Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) -
        Reference: km/h
        Intelligent Tester Indication (km/h) Acceptable Range (km/h)
        20 21.0 to 25.0
        40 41.7 to 46.2
        60 62.7 to 67.2
        80 83.4 to 88.4
        100 104.3 to 109.3
        120 125.1 to 130.6
        140 145.8 to 151.8
        160 166.2 to 173.2
        180 186.9 to 194.5
        200 207.7 to 215.7
        220 228.4 to 236.8

    2. INSPECT TACHOMETER


      1. Connect the intelligent tester, and start the engine.

      2. Compare the test results with the tachometer indications.

        DC 13.5 V, at 25°C (77°F)
        Intelligent tester Indication (rpm)

        Acceptable Range

        Data in ( ) is for Reference
        700 630 to 770
        1000 (900 to 1100)
        2000 (1850 to 2150)
        3000 2800 to 3200
        4000 (3800 to 4200)
        5000 4800 to 5200
        6000 (5750 to 6250)
        7000 6700 to 7300

    3. CHECK LED ILLUMINATION


      1. Check the illumination function of the warning or indicator lights listed below when turning the ignition switch to ON.

        OK
        Warning or Indicator Light Specified Condition
        Leveling*1 Warning or indicator light comes on for about 3 seconds after turning the ignition switch to ON.
        Master*2
        AFS off*3
        ECO
        Brake
        Slip
        ABS
        SRS Warning light comes on for about 6 seconds after turning the ignition switch to ON.
        Oil pressure Indicator or warning light comes on when turning the ignition switch to ON.
        Charge
        EPS
        MIL (Check engine warning light)

        • *1: w/ Automatic Headlight Beam Level Control System

        • *2: w/ Multi-information Display

        • *3: w/ AFS (Adaptive Front-lighting System)