METER / GAUGE SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Warm up the engine.

    2. Turn the ignition switch off.

    3. Connect the intelligent tester to the DLC3.

    4. Turn the ignition switch to ON.

    5. Turn the intelligent tester on.

    6. Enter the following menus:


      1. for Combination Meter: Body / Combination Meter / Data List.

      2. for ABS/VSC/TRC: Chassis / ABS/VSC/TRC / Data List.

      3. for Engine and ECT: Powertrain / Engine and ECT / Data List.

      4. for Main Body: Body / Main Body / Data List.

    7. Check the values by referring to the table below.

      Combination Meter
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      ODO/TRIP Change SW ODO/TRIP change switch/OFF or ON OFF: Switch released -
      ON: Switch pushed -
      P-Seatbelt Buckle SW Front passenger seat belt buckle switch/OFF or ON OFF: Front passenger seat belt fastened (warning light off) -
      ON: Front passenger seat belt unfastened (warning light on)
      Vehicle Speed Meter Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost the same as actual vehicle speed -
      Engine Rpm Engine speed/Min.: 0 rpm, Max.: 12750 rpm

      • 600 to 700 rpm: Idling (for 2GR-FE)

      • 610 to 710 rpm: Idling (for 2AR-FE, 1AZ-FE)

      		 -
      Coolant Temperature Engine coolant temperature/-40 to 127.5°C (-40 to 261.5°F) After warming up: 75 to 100°C (167 to 212°F) -
      Washer Switch Washer fluid level warning switch/OFF or ON OFF: Washer fluid level not low -
      ON: Washer fluid level low
      Fuel Input Fuel input/Min.: 0, Max.: 127.5 Fuel receiver gauge indicates F: 57.0 Unit: Liter
      Fuel receiver gauge indicates 3/4: 48.3
      Fuel receiver gauge indicates 1/2: 32.2
      Fuel receiver gauge indicates 1/4: 16.1
      Fuel receiver gauge indicates E: 6.4
      Multi Display Select Switch*1 DISP switch in the steering pad switch assembly/OFF or ON OFF: DISP switch in the steering pad switch assembly not pressed -
      ON: DISP switch in the steering pad switch assembly pressed
      +B Voltage Value Battery voltage/Min.: 0 V, Max.: 25.5 V 11 to 14 V -
      Ambient Temperature Outside temperature/Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F) Almost the same as actual outside temperature The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F)
      Oil Pressure Switch Oil pressure switch/OFF or ON OFF: Engine starts -
      ON: Engine does not start
      Turn Signal Switch (Left) LH turn signal switch/OFF or ON OFF: LH turn switch off -
      ON: LH turn switch on
      Turn Signal Switch (Right) RH turn signal switch/OFF or ON OFF: RH turn switch off -
      ON: RH turn switch on
      Hazard Flasher Switch Hazard warning switch/OFF or ON OFF: Switch released -
      ON: Switch pushed
      Key Remind Sound Cycle of the key reminder warning buzzer The cycle of the key reminder warning buzzer/Large, Medium, Small -
      Driver seatbelt Warning Buzzer Condition of the seat belt warning buzzer/OFF or ON OFF: Seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when driver seat belt unfastened Displays customize setting of driver side seat belt warning buzzer
      ON: Seat belt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when driver seat belt unfastened
      P-Seatbelt Warning Buzzer Condition of the seat belt warning buzzer/OFF or ON OFF: Seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when front passenger seat belt unfastened Displays customize setting of front passenger side seat belt warning buzzer
      ON: Seat belt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when front passenger seat belt unfastened
      Lane Change Flashing Times Setting Condition of the lane change flashing times setting/OFF, 3, 4, 5, 6, 7 OFF, 3, 4, 5, 6, 7 Displays customize setting of lane change flashing times setting
      Number of Trouble Code The number of DTC currently stored/Min.: 0, Max.: 255 0 -

      • *1: w/ DISP Switch

      ABS/VSC/TRC
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Vehicle Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
      Engine and ECT
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Injection Volum (Cylinder 1) Injection volume (cylinder 1)/Min.: 0 ml, Max.: 2.047 ml 0 to 0.5 ml

      • Stored as Freeze Frame Data

      • This is the fuel injection volume for 10 injections.

      Results of real-vehicle check (for 2AR-FE):


      • Idling (engine warmed up): 0.108 ml

      • Running without load (3000 rpm): 0.097 ml

      Results of real-vehicle check (for 2GR-FE):


      • Idling (engine warmed up): 0.083 ml

      • Running without load (3000 rpm): 0.093 ml

      • Vehicle driven at constant speed of 60 km/h (37 mph): 0.197 ml

      Results of real-vehicle check (for 1AZ-FE):


      • Idling (engine warmed up): 0.087 ml

      • Running without load (3000 rpm): 0.089 ml
      Engine Speed Engine speed/Min.: 0 rpm, Max.: 16383 rpm

      • 600 to 700 rpm: Idling (for 2GR-FE)

      • 610 to 710 rpm: Idling (for 2AR-FE, 1AZ-FE)

      • Stored as Freeze Frame Data

      • When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 rpm or varies greatly from the actual engine speed.

      Results of real-vehicle check:

      Idling (engine warmed up and A/C off): 660 rpm
      Coolant Temp Coolant temperature/Min.: -40°C (-40°F), Max.: 140°C (284°F) 75 to 100°C (167 to 212°F): After warming up

      • Stored as Freeze Frame Data

      • This is the engine coolant temperature.

      Tech Tips


      • After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).

      • After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature are approximately equal.

      • If the value is -40°C (-40°F), or 140°C (284°F), the sensor circuit is open or shorted.

      • Check if the engine overheats when the value indicates 140°C (284°F).
      Main Body
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Illumination Rate Info Illumination rate information/0 ms to 2162.65 ms Value output according to ambient light level -

  2. ACTIVE TEST

    Tech Tips

    Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Combination Meter / Active Test.

    5. Check the operation by referring to the table below.

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Speed Meter Operation Speedometer OFF, 0, 40, 80, 120, 160, 200, 240 km/h -
      Tacho Meter Operation Tachometer OFF, 1000, 2000, 3000, 4000, 5000, 6000, 7000 rpm -
      Fuel Meter Operation Fuel receiver gauge OFF, Empty, 1/2, Full -
      Fuel Consumption Meter Operation Fuel consumption meter OFF, MIN, 1/4, 1/2, 3/4, MAX -
      A/T Indicator Operation 1 Shift indicator light OFF, L, 2, 3(M), 4(M), D, N, R, P -
      A/T Indicator Operation 2 Shift indicator light OFF, 8, 5, 6, 7, Es, B -
      A/T Indicator Operation 3 Shift indicator light OFF, D -
      Indicat. Lamp Airbag SRS warning light OFF or ON -
      Indicat. Lamp Doors All Open Door indicator light OFF or ON -
      Driver Side Seat Belt Seat belt warning light OFF or ON -
      Indicat. Lamp ABS ABS warning light OFF or ON -
      Indicat. Lamp Charge Charge warning light OFF or ON -
      Indicat. Lamp Slip Slip indicator light OFF or ON -
      Indicat. Lamp Beam High beam indicator light OFF or ON -
      Indicat. Lamp Tail Tail indicator light OFF or ON -
      Indicat. Lamp Fr FOG Front fog indicator light OFF or ON -
      Indicat. Lamp Rr FOG*1 Rear fog indicator light OFF or ON -
      Indicat. Lamp Washer Washer fluid level warning light OFF or ON -
      Indicat. AFS*2 AFS warning light OFF or ON -
      Indicat. Lamp Fuel Fuel level warning light OFF or ON -
      VSC TRC Indicator TRC OFF indicator light OFF or ON -
      Indicat. Oil Pressure Oil pressure warning light OFF or ON -
      Indicat. ECONO ECO indicator light OFF or ON -
      Indicat. Lamp Cruise*3 Cruise control indicator light (green) OFF or ON -
      Indicat. Lamp Brake Brake warning light OFF or ON -
      Indicat. EPS EPS warning light OFF or ON -
      Master Warning*5 Master warning light OFF or ON -
      Indicat. SET SET indicator light OFF or ON -
      Indicat. VSC OFF VSC off indicator light OFF or ON -
      Cruise Indicator*3 Cruise control indicator light (amber) OFF or ON *6
      Turn Signal (Left) Indicator Turn LH indicator light OFF or ON -
      Turn Signal (Right) Indicator Turn RH indicator light OFF or ON -
      Smart System Indicator*4 Smart entry and start system warning light (green) OFF or ON -
      Smart System Warning*4 Smart entry and start system warning light (orange) OFF or ON *7
      Water Temperature Meter Operation Engine coolant temperature receiver gauge OFF, LOW, NORMAL, HIGH -
      Meter Display 1 Multi-information display*5 / LCD display OFF, 6, 5, 4, 3, 2, 1, 0, All *8
      Meter Display 2 LCD display OFF, 9, 8, 7 -

      • *1: w/ Rear Fog Light

      • *2: w/ AFS (Adaptive Front-lighting System)

      • *3: w/ Cruise Control System

      • *4: w/ Smart Entry and Start System

      • *5: w/ Multi-information Display

      • *6: The cruise control indicator light (amber) can be operated by selecting this item.

      • *7: The smart entry and start system warning light (orange) can be operated by selecting this item.

      • *8: The multi-information display operates only when All is selected for Control Range.