FRONT DOOR COURTESY SWITCH INSTALLATION

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.


  1. INSTALL FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY


    1. Using a T30 "TORX" socket wrench, install the front door courtesy light switch assembly with the screw.

      Torque:
      6.3 N*m  { 64 kgf*cm, 56 in.*lbf }

      Tech Tips

      There are 2 diameters for the "TORX" screws: 6 mm (0.236 in.) and 7 mm (0.276 in.). The diameter of a supplied "TORX" screw is 7 mm (0.276 in.).

    2. Connect the connector.

  2. INSTALL CENTER PILLAR LOWER GARNISH


    1. Engage the 2 claws and 3 clips to install the center pillar lower garnish LH.

  3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

    for LH Side: Click here

    for RH Side: Click here

  4. INSTALL REAR DOOR SCUFF PLATE


    1. Engage the 6 claws to install the rear door scuff plate LH.

      Tech Tips

      Engage the claws from the rear side of the scuff plate.

  5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

    for LH Side: Click here

    for RH Side: Click here

  6. INSTALL FRONT DOOR SCUFF PLATE


    1. Engage the 10 claws to install the front door scuff plate LH.