ELECTRICAL KEY OSCILLATOR (for Front Floor) REMOVAL


  1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A01EYT0

      Turn the shift lever knob sub-assembly counterclockwise and remove the shift lever knob sub-assembly.

  2. REMOVE FRONT PANEL GARNISH LH


    1. A01EXDU

      Disengage the 3 clips and 8 guides to remove the front panel garnish LH as shown in the illustration.

  3. REMOVE FRONT PANEL GARNISH RH


    1. A01EYBQ

      Disengage the 3 clips and 8 guides to remove the front panel garnish RH.

  4. REMOVE REAR CONSOLE UPPER PANEL SUB-ASSEMBLY


    1. Move the shift lever to N.

    2. Disengage the 6 clips as shown in the illustration.

      A01EV3G

    3. Disconnect each connector to remove the rear console upper panel sub-assembly.

  5. REMOVE UPPER CONSOLE BOX SUB-ASSEMBLY


    1. A01EXR2

      Remove the 2 screws.

    2. A01EX6A

      Disengage the 4 clips and 2 guides as shown in the illustration.

    3. A01EY1N

      Disengage the clamp.

    4. Disconnect the 2 connectors to remove the upper console box sub-assembly.

  6. REMOVE NO. 4 CONSOLE BOX DUCT


    1. A01EXFJ

      Disengage the claw and remove the No. 4 console box duct.

  7. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY


    1. A01EW4U

      Disengage the clamp.

    2. Remove the bolt.

    3. Disconnect the connector and remove the No. 1 indoor electrical key antenna assembly.

      Note

      Be careful when removing the indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.