REAR VIEW MONITOR SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips

Use the following procedure to troubleshoot the rear view monitor system.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.


      NEXT

  3. PROBLEM SYMPTOM CONFIRMATION

    Result
    Result Proceed to
    Symptom does not occur A
    Symptom occurs B

    B

    Go to step 5
    A

  4. SYMPTOM SIMULATION


    NEXT

  5. CHECK IF SAME SYMPTOM APPEARS IN AUDIO AND VISUAL SYSTEM (for Radio and Display Type)


    1. Refer to the audio and visual system (for Radio and Display Type) Click here.

      Result
      Result Proceed to
      Symptom does not appear A
      Symptom appears (follow the audio navigation symptom table to perform troubleshooting) B

      B

      GO TO AUDIO AND VISUAL SYSTEM (for Radio and Display Type) Click here

      A

  6. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table A
      Fault is listed in Problem Symptoms Table B

      B

      Go to step 8
      A

  7. PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM


    1. Terminals of ECU Click here


      NEXT

  8. ADJUST, REPAIR OR REPLACE


    NEXT

  9. CONFIRMATION TEST


    NEXT
    END