HARD DISK DRIVE REMOVAL


  1. PRECAUTION

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

    • A hard disk drive (HDD) is built into the navigation receiver assembly to store map and other data and is used for the navigation system. Therefore, make sure to read all of the precautions thoroughly before handling the navigation receiver assembly.

    • When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT PANEL GARNISH LH


    1. A01EXDU

      Disengage the 3 clips and 8 guides to remove the front panel garnish LH as shown in the illustration.

  4. REMOVE FRONT PANEL GARNISH RH


    1. A01EYBQ

      Disengage the 3 clips and 8 guides to remove the front panel garnish RH.

  5. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A01ETO0

      Using a moulding remover, pry up on the center instrument cluster finish panel sub-assembly until there is enough of a gap to make it possible to pull on the panel by hand.

    2. A01EVW2

      Pull the center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 7 clips and 2 guides to remove the center instrument cluster finish panel sub-assembly as shown in the illustration.

  6. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. A01EUQP

      Pull the No. 2 instrument panel register assembly in the direction indicated by the arrow to disengage the 4 clips as shown in the illustration.

    2. Disconnect the connector to remove the No. 2 instrument panel register assembly.

  7. REMOVE FRONT CONSOLE UPPER PANEL GARNISH


    1. for Blank Type:


      1. A01EVN1

        Disengage the 2 claws and remove the front console upper panel garnish as shown in the illustration.

    2. for 3 Switch Hole Type:


      1. A01EY7R

        Disengage the 2 claws as shown in the illustration.

      2. Disconnect the each connector to remove the front console upper panel garnish.

  8. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY


    1. A01EU97E01
      Text in Illustration
      *1 Protective Tape

      Apply protective tape to the area shown in the illustration.

    2. A01EWLR

      Remove the 4 bolts.

    3. A01EW14

      Pull the navigation receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 6 clips.

    4. Disconnect each connector and remove the navigation receiver assembly with air conditioning control assembly.

  9. REMOVE NO. 2 RADIO RECEIVER BRACKET


    1. A01EXPF

      Remove the 5 screws and No. 2 radio receiver bracket.

  10. REMOVE HARD DISK DRIVE


    1. A01ET78

      Remove the 2 screws.

    2. Disengage the 2 guides to remove the cover.

    3. A01EX4A

      Pull out the hard disk drive from the navigation receiver assembly in the direction shown by the arrow in the illustration to remove it.