NAVIGATION RECEIVER INSTALLATION


  1. PRECAUTION

    Note

    When installing the hard disc drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

  2. INSTALL NAVIGATION ECU SUB-ASSEMBLY

  3. INSTALL HARD DISK DRIVE


    1. A01EU27

      Insert the hard disk drive as shown in the illustration.

    2. Engage the 2 guides to temporarily install the cover.

    3. Install the cover with the 2 screws.

  4. INSTALL AIR CONDITIONING CONTROL ASSEMBLY


    1. A01EX2D

      Engage the guide and 4 clips to install the air conditioning control assembly as shown in the illustration.

  5. INSTALL NO. 1 RADIO RECEIVER BRACKET


    1. Install the No. 1 radio receiver bracket with the 5 screws.

  6. INSTALL NO. 2 RADIO RECEIVER BRACKET


    1. Install the No. 2 radio receiver bracket with the 5 screws.

  7. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY


    1. Connect each connector.

    2. Engage the 6 clips to the vehicle body to temporarily install the navigation receiver assembly with air conditioning control assembly.

    3. Install the navigation receiver assembly with air conditioning control assembly with the 4 bolts.

  8. INSTALL FRONT CONSOLE UPPER PANEL GARNISH


    1. for Blank Type:


      1. A01EX5P

        Engage the 2 claws to install the front console upper panel garnish as shown in the illustration.

    2. for 3 Switch Hole Type:


      1. Connect each connector.

      2. A01EUCV

        Engage the 2 claws to install the front console upper panel garnish as shown in the illustration.

  9. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. Connect the connector.

    2. A01ETDJ

      Engage the 4 clips to install the No. 2 instrument panel register assembly.

      Note

      When installing the No. 2 instrument panel register assembly, check that the wire harness is not caught between the No. 2 instrument panel register assembly and duct.

  10. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A01EWUZ

      Engage the 7 clips and 2 guides to install the center instrument cluster finish panel sub-assembly.

  11. INSTALL FRONT PANEL GARNISH RH


    1. A01EYF4

      Engage the 3 clips and 8 guides to install the front panel garnish RH.

  12. INSTALL FRONT PANEL GARNISH LH


    1. A01ETI1

      Engage the 3 clips and 8 guides to install the front panel garnish LH.

  13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  14. INSPECT HARD DISK DRIVE

    Click here

  15. REPLACED OPERATION (w/ Parking Assist Monitor System)

    Click here